Harbor 1650 PSI - Manual (Page 12)

Page 12 For technical questions, please call 1-800-444-3353. SKU 69488
Sa
FE
ty
Op
ER
ati
O
n
m
aint
Enanc
E
SE
tup
General Operating instructions
1. Point the Nozzle in a safe direction. Press in the
Safety Lock Button to unlock the Trigger and
squeeze the Trigger to check that all pressure is
released from the unit. Release the Trigger.
note: The Gun’s safety lock feature locks the Trigger
when not in use. To unlock the unit and use the gun,
press the Safety
Lock Button and
squeeze the
Trigger. The
safety lock will
re-engage when
you release the
Trigger.
2. Turn on the water supply.
3. Turn on the Power Switch.
note: If the unit does not turn on or turns off
suddenly, check and reset the GFCI.
4. Unlock the Safety Lock Button and squeeze
the Trigger to start the stream. Be aware that
when it is first started, the gun will kick back.
5. Test spray the edge of the surface to be cleaned
to make sure that the stream is not too strong for
the surface. Adjust the pressure by squeezing
the Trigger more or less, and by changing your
distance from the surface. Adjust the stream from
a fan to a direct stream by turning the nozzle.
6. When finished using the Pressure Washer,
release the Trigger, turn the Power Switch off,
unplug the unit, and turn off the water supply.
7. Point the Nozzle in a safe direction and press
the Safety Lock Button and squeeze the
trigger to check that all pressure is released
from the unit. Release the Trigger.
8. Clean, then store indoors, out of children’s reach.
Safety Lock
Button
Trigger
Power
Switch
ON