Harbor 1650 PSI - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. SKU 69488
Sa
FE
ty
Op
ER
ati
O
n
m
aint
Enanc
E
SE
tup
assembly
note: For additional information regarding
the parts listed in the following pages,
refer to Parts Lists and Assembly Diagrams on page 16.
Some of the following assembly steps may have been performed at the factory.
1. Check the Inlet Strainer for any blockage, including
packaging debris. Remove any plastic plugs from the water
inlet/outlet.
2. Attach the Gun/Extension Nozzle holder to the side of the
body.
3. Attach the Handle to the front of the Body with the
four included Screws.
4. Thread the High Pressure Hose onto the Pressure Hose
Outlet on the back of the body.
5. Thread the High Pressure Hose to the Spray Gun.