Muratec F-116 - Manual (Page 85)

Alignment and Troubleshooting
4-25
LCD Display
Descriptions Solutions
NO. Not Assigned The one-touch or speed dial location
you tried to use has no number
assigned to it
Dial the number manually using the
number keypad or assign the number.
Load Document
You have attempted to set up a copy
or fax operation with no document
loaded.
Load a document and try again.
Cancel ?
1:Yes 2:No
Your machine’s memory has become
full while documents were being
loaded into memory.
To cancel the fax job, press the No
1 button Yes. If you want to send the
pages already stored, press the No
2 button No. You should send the
remaining pages later when the
memory is available.
Operation Not
Assigned
You are doing in the Add/Cancel
operation, but there is no jobs waiting.
Check the display to see if there is any
scheduled job. The display should
indicate them in standby mode, for
example, Delay Fax.
[Low Heat Error]
Temperature could not reach certain
level.
Refer to the flow chart of the fuser
problem.
Open Heat Error
The thermistor has been disconnected.
Refer to the flow chart of the fuser
problem.
[Over Heat]
Temperature has gone up very high
degree.
Refer to the flow chart of the fuser
problem.
[Jam 1] or
[No Cartridge]
There is no Cartridge in MFP. Install the toner cartridge.
Toner Exhausted
Replace Toner
The cartridge is out of toner. Replace the toner cartridge.
Toner Empty
Replace Toner
Toner is empty, replace or order for
new toner.
Replace the toner cartridge.
Non Muratec
Cartridge When NON-Muratec cartridge is
inserted in MFP.
Replace the toner cartridge.