Muratec F-116 - Manual (Page 64)

Alignment and Troubleshooting
4-4
4.1.3 JAM Removal
4.1.3.1 Clearing Original Document Jams
When an original jams while passing through the document feeder, a warning message appears on the
display screen.
Input Misfeed
1. Remove any remaining originals from the
document feeder.
2. Pull the jammed document gently out of the
document feeder.
3. Load the documents back into the document
feeder.
Exit Misfeed
1. Remove any remaining originals from the
document feeder.
2. Open the control panel by gripping it on the
bottom edge and pulling it.
3. Pull the document gently out of the document
feeder.
4. Close the control panel. Then load the
documents back into the document feeder.
Note: Ensure the number of originals you place in the ADF does not exceed its tray capacity.