3Com 3500 - Manual (Page 365)

bridge vlan stpMode 365
✓ 3500
✓ 9000
9400
3900
9300
bridge vlan stpMode For CoreBuilder 9000: Applies to Layer 3 switching modules only.
If allClosed mode is enabled, allows the system to ignore the Spanning
Tree Protocol (STP) state for a specified VLAN interface or all interfaces,
for either routing or bridging.
Valid Minimum Abbreviation
b v st
Important Considerations
■
This mode is valid only if the VLAN mode is set to allClosed .
■
To disable the STP state on a per-port basis with either allOpen or
allClosed mode, use the
bridge port stpState
command. See
Chapter 10.
■
If you have configured router port IP interface (and therefore have a
router port VLAN), the ignore STP mode is enabled and cannot be
changed. You cannot select a router port VLAN with this command.
Options
Bridge VLAN STP Mode Example (3500)
Prompt Description Possible Values [Default]
VLAN
interface
index System-assigned index number that
is associated with the VLAN
■
Any
selectable
VLAN index
number
■
all
■
? (for a list of
selectable
indexes)
–
STP state Whether you want to ignore the STP
state for the VLAN index
■
disabled
■
enabled
disabled
selection VID ports name
1 1 1-13 Default
2 2 3,5-9,11 IP1
Select VLAN interface index(es) (1-2|all|?):2
Ignore STP state for VLAN index: 2 (disabled,enabled) [disabled]:enabled