3Com 1100 - Manual (Page 102)

102 C HAPTER 4: W ORKING W ITH THE C OMMAND L INE I NTERFACE
bridge port vltMode Enables or disables VLT tagging on a port on
the current Switch unit.
bridge stpForwardDelay Sets the bridge Forward Delay spanning tree
parameter.
bridge stpHelloTime Sets the bridge Hello Timer spanning tree
parameter.
bridge stpMaxAge Sets the bridge Maximum Age spanning tree
parameter.
bridge stpPriority Sets the spanning tree bridge priority.
bridge stpState Enables and disables the spanning tree
protocol.
bridge vlan addPort Adds a single port to a VLAN. Also allows you
to add all ports on the current Switch unit to
the selected VLAN.
bridge vlan create Creates a VLAN.
bridge vlan delete Deletes a single VLAN.
bridge vlan detail Displays detailed information about a VLAN,
such as port membership and statistics.
bridge vlan modify Modifies the VLAN name for a specified VLAN
ID.
bridge vlan removePort Removes a single port from a VLAN.
bridge vlan summary Displays summary information about a VLAN,
specifically the port membership.
ethernet autoNegotiation Enables and disables auto-negotiation for ports
on the current Switch unit in the stack.
ethernet flowControl Enables and disables IEEE 802.3x flow control
for ports on the current Switch unit in the stack.
ethernet portMode Specifies the speed and duplex mode of ports
on the current Switch unit in the stack
ethernet portState Enables and disables ports on the current
Switch unit in the stack.
ethernet statistics Displays statistical information about ports on
the current Switch unit in the stack.
ethernet summary Displays summary information about the ports
on the current Switch unit in the stack.
feature analyzer add Configures the roving analysis port (that is the
port that the network analyzer will be
connected to) on any unit in the stack.
Table 8 Command line interface commands
Command What does it do?