3Com 1100 - Manual (Page 104)

104 C HAPTER 4: W ORKING W ITH THE C OMMAND L INE I NTERFACE
snmp get Performs an SNMP GET command, that allows
you to retrieve values of SNMP objects from the
stack.
snmp next Performs an SNMP GETNEXT command, that
allows you to specify an SNMP object and then
retrieve the next few SNMP objects from the
stack.
snmp set Performs an SNMP SET command, that allows
you to modify the value of an SNMP object in
the stack.
snmp trap define Specifies the trap destination details for the
stack.
snmp trap display Displays the details of the current trap
destinations for the stack.
snmp trap modify Modifies trap destination details for the stack.
snmp trap remove Removes trap destination details from the stack.
system display Displays administration details for the current
Switch unit in the stack.
system information Specifies administration details for the stack.
system initialize Initializes the Switch units in the stack.
system inventory Displays a list of the Switch units in the stack.
system module define Sets the IP configuration for a Switch Layer 3 or
Switch ATM module.
system module display Displays the module configuration details.
system module mode Allows you to enable or disable an intelligent
module.
system password Specifies the password for the current user.
system remoteAccess Enables and disables all forms of remote access
to the stack.
system reset Resets the Switch units in the stack.
system security access
display
Displays the access rights for all access levels in
the stack.
system security access
modify
Modifies the access rights for the access levels
in the stack.
system security user
define
Specifies the user details for the stack.
system security user
display
Displays the user details for the stack.
Table 8 Command line interface commands
Command What does it do?