Pioneer DJM-500 - Manual (Page 4)

4
<DRB1192>
Location
Install the unit in a well-ventilated location where it will
not be exposed to high temperatures or humidity.
Do not install the unit in a location which is exposed to
direct rays of the sun, or near stoves or radiators. Exces-
sive heat can adversely affect the cabinet and internal com-
ponents. Installation of the unit in a damp or dusty envi-
ronment may also result in a malfunction or accident. (Avoid
installation near cookers etc., where the unit may be ex-
posed to oily smoke, steam or heat.)
Condensation
When this unit is brought into a warm room from previ-
ously cold surroundings or when the room temperature
rises sharply, condensation may form inside, and the unit
may not be able to attain its full performance. In cases like
this, allow the unit to stand for about an hour or raise the
room temperature gradually.
• Power cord
CHECKING ACCESSORIES CAUTIONS REGARDING HANDLING
• Short-circuit pin plug (four)
These are inserted in the PHONO 1 and PHONO 2 termi-
nals at the rear.
• Operating instructions
Cleaning the unit
• Use a polishing cloth to wipe off dust and dirt.
• When the surfaces are very dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water and wrung out well, then wipe again with a
dry cloth. Do not use furniture wax or cleaners.
• Never use thinners, benzene, insecticide sprays or other
chemicals on or near this unit, since these will corrode
the surfaces.