Hama MW1002 - Manual (Page 36)

d Bedienungsanleitung
GB
36 MW-1002
Setting the time (CLOCK)
NOTE
The time and programmed settings must be reset
after the batteries are changed. ►
Set the time according to the chapter entitled “Changing
the settings”.
Set the minutes by pressing the “+/ ” [7] or “-” [16]
buttons, then press the SET button [8].
Set the hour by pressing the “+/ ” [7] or “-” [16]
buttons.
Press the MODE button. The time display flashes
several times in quick succession. The time is shown
in the display [1].
Setting the unit of measurement (UNIT)
You can switch between the units “‰ BAC” (BAC = blood
alcohol content) and “mg/l”.
Set the unit of measurement according to the chapter
entitled “Changing the settings”.
Press the “+/” [7] or “-” [16] button to select the
appropriate unit of measurement. This unit is then
shown on the display [2 or 10].
Press the SET button [8] to save the setting. The
display flashes several times in quick succession and
the device exits the settings mode.
u
u
u
u
u
u
u
00087697bda_neu.indd 36 00087697bda_neu.indd 36 03.08.2009 9:58:10 Uhr 03.08.2009 9:58:10 Uhr