ResMed Mirage Swift II - Manual (Page 17)

17
English
Intended Use
The mask directs airfl ow noninvasively to a user from a positive airway pressure
device such as a continuous positive airway (CPAP) or bilevel system.
The mask is intended for:
• adult users (>30 kg) for whom positive airway pressure has been prescribed
• single user re-use in the home environment and multipatient re-use in the
hospital/institutional environment.
Using the Mask
• Refer to the Technical specifi cations section in this user guide for mask setting
options.
• Follow the instructions provided by your physician or sleep therapist.
• To fi t your mask, follow the instructions in the Fitting section.
• Do not overtighten the headgear straps. If you feel air-leaks you may need to:
– refi t or reposition your mask
– adjust your headgear
– check that your mask is assembled correctly
– contact your physician or sleep therapist to have your mask refi tted.
• Mask-specifi c user guides are available on www.resmed.com on the Products
page under Service & Support. They are also available from ResMed upon
request.
The mask system does not contain latex, PVC or DEHP materials.
Device Settings
The mask setting options for ResMed devices are listed in the “Mask Compatability
Table” on www.resmed.com on the Products page under Service & Support.
Disassembly
To disassemble your mask, follow the instructions in the Disassembly section.
Reassembly
To assemble your mask, follow the instructions in the Reassembly section.
Cleaning the Mask at Home
• The mask and headgear can only be handwashed. The headgear may be
washed without removing the headgear clips.
• Take care when cleaning to avoid damage or loss of components.
Daily/After Each Use
• To optimise mask seal, remove facial oils from the cushion before use.
• Do not soak the mask.
• Handwash the mask by rubbing gently in warm (30°C) water using mild soap
or diluted dishwashing detergent.
• Rinse all components well with drinking quality water and allow them to air dry
out of direct sunlight.
• If the vent is blocked, clean it using a soft bristle brush.
Weekly
Handwash the headgear in warm (30°C) water using mild soap or diluted
dishwashing detergent. Rinse well and allow it to air dry out of direct sunlight.
Technical Specifi cations
Pressure-fl ow curve – all masks
V
ent fl
ow rat
e (L/min)
0
10
20
30
40
50
60
4 6 8 10 12 14 16 18 20
Mask pressure (cm H
2
O)