STIEBEL ELTRON SBP E с 12.04.2008 - Manual (Page 17)

www.stiebel-eltron.com sBp 1000-1500 e | e sol | e cool | 17
EN
G
LI
SH
installation
preparing for installation
f f On cylinders supplied horizontally, insert the bottom thermal
insulation section inside the support ring, prior to position-
ing the cylinder. Slightly tip the vertically delivered cylinder
in order to position the bottom thermal insulation section.
f f Surround the support ring with the bottom thermal insula-
tion ring and secure it with adhesive tape.
f f Remove the foil from the 5 foam strips (convection brakes)
and stick them around the cylinder in the positions shown.
f f Prior to fitting them, shape the right hand and left hand ther-
mal insulation sections into a semi-circular form for approx.
10 seconds. A pressure-activated adhesive then holds the
thermal insulation sections in the required shape and makes
fitting them easier.
Please note that the use of tensioning straps may damage the
thermal insulation.
f f Push the thermal insulation sections over the connections on
the appliance.
f f Connect the thermal insulation sections at the front by clip-
ping the hook closure strip into the last hook strip. If neces-
sary, the short black cover strips can be used to temporarily
hold the hook closure strips together.
f f Position the thermal insulation sections around the cylinder
and connect the thermal insulation sections at the back by
clipping the hook closure strip into the first or second hook
strip.
f f Adjust the thermal insulation sections on the appliance by
patting and pressing them down with the palm of the hand.
f f Starting from the top, retighten the hook closure strip from
the top until it hooks into the final hook strip.
f f Place the thermal insulation ring and the two thermal insula-
tion sections on the top.
f f Place the cover over the thermal insulation sections.
f f Fit the cover strips onto the hook closure strips. If required,
the cover strips can be trimmed to size.
f f Fill the hollow spaces near the connections with the soft
foam inserts.
f f Push the roses and caps into the apertures.
Note
Affix the additional type plate in a clearly visible position
on the thermal insulation.
9.2 installing the manual air vent valve
26
�0
3�
01
�0
97
3
f f Install a manual air vent valve at the air vent valve
connection.
9.3 Fitting the temperature sensor
f f Fill the protective pipe with heat conducting paste.
f f Insert the sensor into the protective pipe until it bottoms.
Prior to inserting contact sensor AVF 6 into the protective pipe,
bend the bias spring forward.
9.4 where appropriate, fit the flanged or threaded
immersion heater.
f f Remove the dummy flanges and plugs in order to mount
the heat exchanger, flanged or threaded immersion heater.
Maintain the DC separation towards the cylinder.