FIAT Freemont User Manual

Page 170

Advertising
background image

(Continued)

• On seven passenger models, do not allow a
passenger to sit in a third row seat with the
second row seatback(s) folded flat. In a collision,
the passenger could slide underneath the seat
belt and be seriously or even fatally injured.

EXHAUST GAS

WARNING!

• Exhaust gases can injure or kill. They
contain carbon monoxide (CO), which is

colorless and odorless. Breathing it can make you
unconscious and can eventually poison you. To
avoid breathing CO follow these safety tips:

Do not run the engine in a closed garage or in confined
areas any longer than needed to move your vehicle in
or out of the area.

If it is necessary to sit in a parked vehicle with the
engine running, adjust your heating or cooling controls
to force outside air into the vehicle. Set the blower at
high speed.

If you are required to drive with the liftgate open, make
sure that all windows are closed, and the blower switch
on the climate control is set at high speed. DO NOT
use the recirculation mode.

The best protection against carbon monoxide entry
into the vehicle body is a properly maintained engine
exhaust system.

Whenever a change is noticed in the sound of the
exhaust system, when exhaust fumes can be detected
inside the vehicle, or when the underside or rear of the
vehicle is damaged, have a competent mechanic inspect
the complete exhaust system and adjacent body areas
for broken, damaged, deteriorated, or mispositioned
parts. Open seams or loose connections could permit
exhaust fumes to seep into the passenger compart-
ment. In addition, inspect the exhaust system each time
the vehicle is raised for lubrication or oil change.
Replace as required.

SAFETY CHECKS YOU SHOULD MAKE
INSIDE THE VEHICLE

Seat Belts
Inspect the seat belt system periodically, checking for
cuts, frays, and loose parts. Damaged parts must be
replaced immediately. Do not disassemble or modify
the system.

Front seat belt assemblies must be replaced after a
collision. Rear seat belt assemblies must be replaced
after a collision if they have been damaged (i.e., bent
retractor, torn webbing, etc.). If there is any question
regarding belt or retractor condition, replace the seat
belt.

163

KNOWING
YOUR
VEHICLE

SAFETY

STARTING
AND
DRIVING

WARNING
LIGHTS AND
MESSAGES

IN AN
EMERGENCY

SERVICING
AND
CARE

TECHNICAL
SPECIFICATIONS

CONTENTS

Advertising