Sony SLV-SE230G - Manual (Page 14)

14 Setting up the remote commander
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
* 1 SLV-SE830G only
* 2 not available on SLV-SE230G/I
Controlling other TVs with the remote commander (SLV-
SE830G only)
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the following table, set the appropriate manufacturer’s code
number.
* These buttons may not work with all TVs.
Switch to Teletext* 1 / (Teletext)
Select the sound* 2 AUDIO MONITOR
Use FASTEXT* 1 FASTEXT buttons
Call up the on-screen display DISPLAY
Change the Teletext page* 1 c
⁄
C
Switch to/from wide mode of a Sony wide TV (For
other manufactures’ wide TVs, see “Controlling
other TVs with the remote commander (SLV-
SE830G only)” below.) (wide)
1 Set [TV] / [VIDEO] at the top of the remote commander to [TV].
2 Hold down ?/1, and enter your TV’s code number using the programme
number buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/VIDEO, programme number buttons, - (ten’s digit),
PROG +/–, 2 +/–, a (TV), / (Teletext), FASTEXT buttons,
(wide)*, MENU*, M / m / < / , *, and OK*.
To Press