HONDA 2012 CR-Z Navigation - Manual (Page 93)

92 Navigation System
CR-Z_KA 31SZT810
System Setup
Guidance Mode
Allows you to select the guidance
display mode:
Single Screen or Split
Screen.
To get to Guidance Mode from the
Setup screen, select in sequence,
“More,” “Routing & Guidance,” and
“Guidance Mode.”
The factory default is Single Screen.
NOTE:
The Guidance Mode can also be
selected on the Icon Selection screen.
See Showing Icons on the Map on
page 59.
Vehicle
From the Setup screen (second), say or
select Vehicle and the following screen
appears:
Off-road Tracking
With this
On, the system will provide
white off-road tracking dots
(“breadcrumbs”) on the
map screen
whenever you drive into an area where
the map does not show any roads.
See Map Screen Legend on page 19.
After you have traveled approximately
1/2 mile away from a mapped road, the
system will display a series of white
dots on the
map screen to show the path
you have traveled. This is provided so
you can follow the dots to backtrack to
the mapped road you originally left.
Tracking continues until you reach a
mapped road. See Off-road Tracking on
page 61.
Tracking is shown only in the 1/20, 1/8,
1/4, and 1/2 mile scales, or the 80, 200,
400, and 800 meter scales. Use the
ZOOM buttons to change the scales if
necessary.
NOTE:
To clear existing dots, turn this feature
off and exit Setup. To re-enable this
feature, return to Setup and turn it on
again.
00 CR-Z_KA.book 92 ページ ２０１１年８月９日 火曜日 午後４時１７分