HONDA 2008 Accord Navigation - Manual (Page 77)

Navigation System 77
System Set-up
Volume
The navigation voice volume can be
adjusted by:
• Using the voice control system and
saying “Volume up” or “Volume
down.”
• Selecting Volume and changing the
setting by rotating the Interface
Dial knob.
• Saying “Volume Off,” or selecting
Volume and then OFF.
NOTE:
If you turn the volume off, you will not
hear route guidance or voice command
confirmations.
Interface Dial Feedback
This setting allows you to control when
(and if) the system will read the current
selection you choose with the Interface
Dial. The purpose of this feature is to
minimize the need to look at the screen
while operating the dial. You can set the
one of three settings explained in the
following table. The factory default is
AUTO.
Guidance Prompts
While you drive to your destination, the
system displays and announces
guidance prompts for your next
maneuver. This setting allows you to
adjust the number of guidance prompts
before each maneuver. The settings
MIN, NORMAL, and MAX are
described below. The factory default is
NORMAL, so you can adequately
prepare for the next maneuver. If you
wish to change the number of guidance
prompts, select your preferred setting,
as shown in the following table.
* Uses street name in guidance phrase.
NOTE:
To temporarily turn off voice guidance
prompts, select
OFF for the Volume
setting in Setup.
Setting Degree of assistance
ON When selection is made,
the system always reads
what is selected.
AUTO
(factory default) The system reads
selection only when
moving.
OFF No voice assistance when
selecting.
Setting Distance before maneuver
About
1/2
mile About
1/4
mile Just
before
maneuver
MIN Yes
NORMAL
(factory default) Yes Yes Yes
MAX Yes* Yes* Yes
2008 Accord
Main Menu