JVC KD-AVX40 - Manual (Page 38)

36
ENGLISH
When a call comes in...
The source is automatically changed to “Bluetooth.”
When <Auto Answer> is activated...
The unit answers the incoming calls automatically.
(☞ page 59)
• When <Auto Answer> is deactivated, press SRC
or touch any control to answer the incoming call.
To end the call or reject an incoming call
Hold SRC or any control.
Answering a waiting call
If your cellular phone is equipped with the call
waiting function, you can put the current call on
hold and answer the waiting call.
Press SRC or touch any control.
• To restore the on-hold call, press SRC or touch
any control again.
• When you end one call, you can connect to the
other.
When an SMS comes in...
If the cellular phone is compatible with SMS
(Short Message Service) and <SMS Notify> is
set to <On> (☞ page 59), the unit rings and
“Receiving Message” appears on the monitor to
inform you of the arrival of the message.
Name and phone number
(if acquired)
You can also enter <Dial Menu> by pressing
on the remote controller then touching
6 on
the unit.
*1 Displays only when the dialed or received number has
been made through the unit.
*2 For copying, ☞ page 37.
*3 For presetting, ☞ page 38.
4
Select the method to make a call.
Redial * 1
Shows the list of phone numbers you have dialed.
= Go to the following step.
Received Calls
* 1
Shows the list of the received calls.
= Go to the
following step.
Phonebook * 2
Shows the phone book copied from a cellular
phone.
= Go to the following step.
Preset Calls * 3
Shows the list of preset numbers.
= Go to the
following step.
Phone Number
Shows the phone number entry screen.
= “How
to enter a phone number” ☞ page 37
Voice Dialing
(Only when the connected cellular phone has the
voice recognition system)
= Speak the name
you want to call. (Refer to the instruction manual
supplied with your cellular phone.)
• To cancel, hold SRC or any control.
5
Select the name/phone number/preset number
you want to call.
• When the sound is stopped or interrupted during the
use of a Bluetooth device, turn off, then turn on the
unit.
– If the sound is not yet restored, connect the
device again. (☞ “Connecting/disconnecting a
registered device” on page 34)
• While talking, you can enter <MIC Setting> to adjust
the microphone volume level by touching MENU. (☞
page 59)
EN_KDAVX4020[E]5.indb 36 EN_KDAVX4020[E]5.indb 36 08.12.25 4:38:11 PM 08.12.25 4:38:11 PM