Candy CBP 62 W - Manual (Page 10)

10
the height work on the screws L, fig. 8).
Fix the hood to the lower angle frame by
means of the screws M.
For a further adjustment act on the screws J
through the holes N (fig. 8).
Fixing the front panel
Remove the grid.
Take off the door O (fig. 9) turning the rear
locking knobs P.
Apply the scheme nr. 3 on the rear side of the
front panel, considering that the arrow
indicates the upper side (fig. 10 ), drill where
indicated by the scheme.
Then fix the door to the front panel by means
of the screws Q (fig. 11).
Fixing
Apply the scheme nr. 2 on the side of the
right cupboard, so that the side B matches
the front part of the cupboard (disregard
the thickness of the flap) and drill two
holes 2,5 mm diameter in the points B1
and B2 (fig. 12).
Then apply the same scheme on the side of
the left cupboard, matching the side C with
the front part of the cupboard (disregard the
thickness of the flap) and drill two holes 2,5
mm diameter in the points C1 and C2 (fig.
13).
Fix the hood to the cupboards by means of
the screws R (fig. 14).
Replace the door, inserting it first in the
upper then in the lower slides, turn the rear
locking knobs P and then mount the metal
filters, following in revers, the operations
described under paragraph
“Internal recy-
cling version”.
Adjust the angle frame tightly to the
wall, making use of the apposite screws
M (fig. 8).
The angle frame has one long arm and one
short arm, to be used in alternative depend-
ing on the depth of the cupboards.
Using the hood
— The hood is provided with several spee-
ds. For the best performance, we recom-
mend using the low speeds in normal
conditions and the high speeds in
particular cases of strong odour and
vapour concentration. The hood is fitted
with a microswitch connected to the flap:
with the flap pushed in, the motors switch
off; with the flap pulled out, the function
previously set will be reactivated.
— It is advisable to switch on the extractor
hood a few minutes before starting coo-
king and then to leave it running for ap-
proximately 15 minutes afterwards to
ensure that all odours are extracted.
Warning!
— The hood cannot be connected to flues
of other appliances that run on energy
sources other than electricity.
— When the hood is used at the same time
of other appliances that run on energy
sources other than electricity, provision
must be made for an adequate supply of
air.
— No food must be cooked flambé under-
neath the hood.
The use of an unprotected flame is dan-
gerous for the filters and could cause
fires.
Therefore, never use an open flame un-
der the hood. When frying foods, never
leave the pan alone because the cook-
ing oil could flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or
its catching on fire because of failure to
observe the above instructions.
Suggestions for the installation and
use of the hood
— The horizontal sections of the pipe must
be slanted slightly upwards (about 10%)
to ensure an easy flow of the air out-
wards.
— The best performance of the unit is ob-
tained in the external exhaust model
(suction), therefore in the limits of the
possibilities it is advised to use the ex-
GB