Candy CBP 62 W - Manual (Page 9)

9
View of the hood
1) Flap
2) Grid
3) Cooking surface lighting
4) Motor speed
5) Light
Use
Two systems are available:
External exhausting version
In this case the fumes are conveyed outside
by means of a special pipe connected with
the coupling flange A, placed in the hole B
(fig. 1).
According to your exigencies the pipe can
be directed either toward the ceiling or to-
wards the walls (fig. 2).
Internal recycling version (filtering)
The air is filtered through a carbon filter and
returned to the room.
To use the hood in this version proceed as
follows:
— Order the carbon filter (1 filter for a hood
with one motor, 2 filters for a hood with 2
motors) from your Service Centre,
making sure to specify the hood model.
— Remove the grid A using locking device
B (fig. 3).
— Insert the carbon filter between points I
so that arrow D on the fan cowling of the
hood matches up with reference point C
on the carbon filter.
Turn the carbon filter clockwise (F)until it
locks (fig. 4).
The deflector E (fig. 5) must be fitted on the
hole B (fig. 1 ) fixing it with the special screw
provided.
The deflector conveys the air frontwards
avoiding to dirty the rear wall.
Installation
When installed. the hood must be not less
than 65 cm. above electric burners or 70
cm. above gas or mixed-fuel burners.
In the vented exhaust version the fumes
outlet duct must be 120 mm. in diameter.
In the horizontal runs the duct must be
slightly slanted (about 10°) and directed
upwards to vent the air easily from the room
to the outside.
Do not tile, grout or silicone this appliance
to the wall. Surface mounting only.
Do not fix chimney flue to furniture or fly
over shelves unless the chimney flue can
be easily removed, in case maintenance is
ever required.
Electrical connection
Before completing any connection, make
sure the house voltage corresponds with
the voltage indicated on the label affixed
inside the hood
It is advisable to call a qualified technician
to make the electrical connection.
Appliance fitted with plug.
Connect it to a socket which conforms with
current regulations.
If you intend to connect it directly to the elec-
tric mains, remove the plug and fit an ap-
proved bipolar switch with a minimum con-
tact opening of no less than 3mm.
If the plug is not accessible once it has been
inserted in the socket, it will however be
necessary to fit an approved bipolar switch
with a minimum contact opening of no less
than 3mm.
Appliance without plug
Fit an approved plug or an approved bipo-
lar switch with a minimum contact opening
of not less than 3mm.
The manufacturers are not liable for any
problems caused by the user’s failure to
observer the above instructions.
Mounting the hood on the wall
Make use of the scheme nr. 1 provided,
applying it on the wall.
Drill where indicated (fig. 6).
Place the hooks F provided with screws and
blocks in the upper holes.
Place the expansion plugs G supplied with
the hood in the lower holes (fig. 7).
Fix the angle frame H (using either the long
or the short arm, depending on the depth of
the side cupboards) to the wall at the right
height.
Adjust the position of the upper brackets I, fix
the hood to the hooks F, check that the hood
is at the right height (to eventually adjust
GB