Candy TR 40 RUV - Manual (Page 23)

23
Before installing the hob :
Πmake sure that the appliance is compatible with the gas supply source.
The hob is pre-set in the factory to work with the type of gas shown on the packing
and the plate attached to it.
Natural gas G 20-20 mbar / G 25-25 mbar : mains gas
 if necessary, adapt the hob for use with another type of gas : if the hob
must be used with another type of gas than the gas pre-set in the factory, it is necessary
to adapt the hob gas burners (page 24/25).
The procedure for adaptation consists of :
. fitting the correct jets to ensure nominal delivery,
. adjusting the appearance of the flame by regulating the air ring according to the
data given in the table.
For installation :
Ž built-in hob (page 26/27).
 make the gas connection according to the type of gas to be used : based on
the gas to be used, choose the appropriate gas connection (page 28).
 make the hob electrical connection according to the instructions (page
29).
‘ adjusting the minimum flame of the taps : if necessary, adjust the minimum
flame of the taps by turning the by-pass screw (page 30).
F
INSTALLATION
Installing a domestic appliance can be a complicated operation which if not
carried out correctly, can seriously affect consumer safety.
It is for this reason that the task should be undertaken by a professionally
qualified person who will carry it out in accordance with the technical regulations
in force.
In the event that this advice is ignored and the installation is carried out by an
unqualified person, ROSIERES declines all responsibility for any technical failure
of the product whether or not it results in damage to goods or injury to
individuals.
All modification concerning the hob gas setting must be indicated on the rating plate
of the hob.
F