Candy TR 40 RUV - Manual (Page 26)

26
INSTALLATION
BUILDING-IN : both the worktop where the hob will be fitted and any adjacent kitchen
furniture must be made from heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower hob face is adjacent to an area normally accessible
when handling or cleaning, fit a heatproof partition 1 cm below the base of the hob with
a 10X10 cm opening at the rear right-hand corner, to avoid any risk of scorching or damage.
There should also be a 5 cm gap between the appliance and all adjacent vertical surfaces.
A foam adhesive is supplied with the hob. Stick this seal under the edge of the body as near
as possible to the outer edge of the hob. Press round the edges of the hob, so that the seal
flattens out and ensures an air tight seal.
Warning : at the rear of the appliance, take care not to block the air inlets necessary for
combustion to take place.
FITTING THE SEAL
• Top view of the seal
• Cross section of the hob
Worktop level
6 mm
seal
- Take care not to block the air inlets
necessary for combustion to take place -
SEAL