Panasonic SDR-S10 - Manual (Page 20)

20
VQT1E14
Setup
4
Connect the AC adaptor
(supplied)
A to this unit and
the AC outlet.
1 Slide the terminal cover lock to OPEN
and then open the terminal cover.
2 Connect the AC cable to the AC
adaptor, then the AC outlet.
3 Connect the AC adaptor to this unit’s
DC input terminal.
≥ The status indicator B starts
blinking in red at intervals of about
2 seconds to signal that charging
has commenced. Charging is
completed when the lamp goes off.
≥ The output plug of the AC cable is
not completely connected to the
AC adaptor jack. As shown in C,
there is a gap.
≥ Do not use the AC cable with any
other equipment as it is designed
only for this unit. Do not use the
AC cable from other equipment
with this unit.
≥ Battery charging time ( l 22)
≥ We recommend using Panasonic
batteries (VW-VBJ10).
≥ If you use other batteries, we cannot
guarantee the quality of this product.
∫ About charging errors
When the status indicator flashes
rapidly or slowly, one of the following
situations may be to blame.
When the status indicator flashes at
intervals of about 6 seconds (on for
about 3 sec. and off for about 3 sec.):
≥ The battery may have excessively
discharged. It can be recharged but in
some cases it may take several hours
until regular charging commences.
≥ The battery temperature or the
ambient temperature may be
extremely high or low and charging
may take time.
When the status indicator flashes at
intervals of about 0.5 second (on for
about 0.25 sec. and off for about 0.25
sec.):
≥ The battery has not been recharged.
Remove the battery from the unit, and
try charging it again.
≥ The battery temperature or ambient
temperature may be extremely high or
low. Wait until the appropriate
temperature is restored before
1
B
4.8V
3
2
A A
C
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only
with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according
to the manufacturer’s instructions.
Warning
Risk of fire, explosion and burns. Do
not disassemble, heat above 60 xC or
incinerate.
VQT1E14(EB_GC_ENG).book 20 ページ ２００７年２月２８日 水曜日 午後２時２３分