Panasonic SDR-S10 - Manual (Page 26)

26
VQT1E14
Setup
Inserting/removing
an SD card
Be sure to set the mode dial to OFF
before inserting/removing an SD card.
1
Set the mode dial to OFF.
≥ Check that the status indicator has
gone off.
2
Slide the card/battery door
lock in the direction of the
arrow and then open the card/
battery door.
≥ When the card/battery door does not
open, place your finger on the [ ] part
and open the card/battery door.
3
Insert/remove the SD card
into/from the card slot.
≥ When inserting an SD card, face the
label side A upwards and press it
straight in as far as it goes.
≥ When removing the SD card, press the
centre of the SD card and then pull it
straight out.
4
Close the card/battery door
and then slide the card/battery
door lock in the direction of
the arrow.
≥ If the card/battery door cannot be
completely closed, remove the card
and then insert it again.
If the SD card is inserted or removed
while the power is on, this unit may
malfunction or the data recorded on
the SD card may be lost.
A
VQT1E14(EB_GC_ENG).book 26 ページ ２００７年２月２８日 水曜日 午後２時２３分