Panasonic SDR-S10 - Manual (Page 99)

Others
99
VQT1E14
It is possible that the system cannot complete writing of a file normally when, for
example, power is turned off for some reason during recording or editing.
If faulty management information is found when the card is accessed, the following
message may appear. Be sure to follow the messages. (Repairing may take time
depending on the error.)
≥ When you repair the data, use a battery with sufficient battery power or the AC
adaptor. Even if the power is turned off without repairing the data, you can repair the
data when you turn the power on again.
≥ Depending on the condition of the data, it may not be possible to completely repair
the data.
≥ Do not repair a card that has been recorded on another device. This may cause the
loss of data or the card.
≥ If the recovery fails, you will no longer be able to playback the scenes recorded
before the power went off.
≥ If the recovery fails, format the SD card on this unit. Please be aware that if an SD
card is formatted, then all the data recorded on the card will be erased.
EXIT THE MENU THEN
CHANGE TO MANUAL
MODE.
You are attempting to use a function that cannot be
used simultaneously.
CANCEL NIGHT VIEW
MODE
PLEASE CONNECT AC
ADAPTOR You are attempting to connect to a computer when
the AC adaptor is not connected.
PUSH THE RESET
SWITCH.
An irregularity in the unit has been detected.
Remove the SD card then press the RESET button
to restart the unit. (
l 106)
DISCONNECT USB
CABLE.
The unit cannot correctly establish the connection
to the computer or printer. Disconnect and
reconnect the USB cable and then select the
desired USB function again.
CANNOT OPERATE WHILE
USB CONNECTED. The unit’s power cannot be turned off when the unit
is connected to the computer.
About recovery
CARD ERROR DETECTED. NOW REPAIRING DATA.
VQT1E14(EB_GC_ENG).book 99 ページ ２００７年２月２８日 水曜日 午後２時２３分