Acclaim Lighting X-Chip Driver IR - Manual

Descriptions:
24-004-2042-00
Rev 2.2
Congratulations with your purchase of this product.
Read this manual carefully before using our Acclaim Lighting X-CHIP-DRIVER-IR. The
is a
combination of a control interface and tension provider for our X-CHIP LED PCB modules as a LED fixture. A
maximum of 24 channels can be controlled separately.
X-CHIP-DRIVER-IR
Check for transport damage.
You should be in possession of the following items:
1 X-CHIP-DRIVER-IR
1 Manual
1 LED Remote(Infrared Remote Control)
1 IR EYE(sensor)
8 Flat cables for connection
Should you discover transport damage after unpacking the equipment, inform the hauler immediately.
Never connect a damaged device. You may also contact your supplier.
Delivery Packet:
X
X-CHIP-DRIVER-IR X-CHIP-DRIVER-IR
Main Features:
Technical Specifications:
Operation temperature
Connection
Housing
Ingress Protection Rating
Control Protocol
Listing
Dimensions
Weights
-10 degC to +50 degC
8 output terminal sockets
2 power in and out terminal sockets
2 DMX in and out terminal sockets
1 IR connect socket
PC +UV resistance
IP20
DMX-512 (1990)
CE certified
195(L) x 110(W) x 22(H)mm
200g
Power Requirement 12-24VDC, 24A Max.
3A(50PCS of X-CHIP-PCB LED Module) capacity for each output(Total 8 ports in 400pcs).
USITT Standard DMX-512(1990) multiplexed digital control.
1~10 patterns plus a sequence of 10 patterns, chase speed & fade time adjustable.
Master/Slave function modes available.
Fully controlled by DMX controller, XB-R1 or Infrared remote.
Loading output modes consists of RGB mode, Color mode, Color &Brightness mode
and Single mode.
DMX Control Mode, Manual Mode and Auto Mode available.
Different Output Group modes for user assignable .
R.G.B color intensity can be adjustable separately.
All work modes and parameters can be set by flipping 10-way Addressing Dip Switch and
8-way Function Dip Switch.
*Please Note: Improvements and specifications in the design of the unit and the manual are subject to change without
any prior written notice.
*Special Note: For reducing signal errors and avoiding signal transmission problems and interference, it is always
advisable to connect 120 ohm impedance DMX signal cable and DMX terminator for signal connection.
Acclaim Lighting - Los Angeles, CA 90058
www.acclaimlighting.com