Acclaim Lighting X-Chip Driver IR - Manual (Page 5)

1 C&B mode: has 1 group with C&B output, which consists of 8 outputs that are controlled by 2 channels.
1
2
C & B
Color
Brightness
Group 1/
Output 1-8
Channel 1-2
1 COLOR mode: has 1 group with Color control, which consists of 1 output that is controlled by
1 channel. The brightness is always 100%.
100%
1
C & B
Color
Brightness
Group 1/
Output 1-8
Channel 1
MODE-11 Patch mode C&B of 16 outputs---->2 outputs(2x1 channels)
MODE-12 Patch mode Color of 8 outputs---->1 outputs(1x1 channels)
NOTE:
1).The Glide Effect function can be switched on(YES) or off(NO). The transition from one level to another is
smoother when this function is switched on.
2).When this function is switched off, the lighting intensity will changed from one level to another abruptly.(thus,
when a quick lighting effect is required, the Guide Effect function should be switched off.)
3).If the DMX signal is interrupted, the driver will keep the last received DMX signal(information) until the driver
is switched off or a new and valid DMX signal is sent.
4).When in link, the Slave will follow the Master, all parameter settings of each slave connected unit will be of
no effect.
3 Blue
MODE-10 Patch mode RGB of 24 outputs---->3 outputs(3x1 channels)
1 RGB mode: in this mode, 8 outputs are patched. The driver has 24 identical outputs distributed over 1 group.
Channel 1-3
Group 1/
Output 1-8
Color (R/G/B)
1 Red
2
1.2.Master Control
(1) AUTO mode:
(2) MANUAL mode:
AUTO mode and MANUAL mode are for Master Control. Relevant functions are as below:
Preset programs:1-10 programs and "AUTO" program ( program is the sequential
running of these1-10 programs.)
"AUTO"
Auto Speed: 1~100. Auto Fadetime: 0%~100%.
BLUE/Duration: 0%~100%. RED/Speed: . 0%~100% GREEN/Dimmer: . 0%~100%
NOTE:
1).The LEDs will turn red in Slave Control mode.
The LEDs will give responding sensitive when the parameters are adjusted in Master Control.
2).If the LED is not selected in "Setup with answer", it will turn red.
If the LED is not selected in :Setup no answer", it will switch off.
When the user confirms the settings of the LED products, the LEDs will flash momentarily to confirm that the
setting have been saved.
-Page 5-