Acclaim Lighting AL Dimmer 3 HP - Manual (Page 2)

-2-
The following contents instruct to how to make the selection for the output current as 350mA or 700mA.
1. Take out the AL-Dimmer-3 HP and the screw driver from packing.
2. Use the screw driver to prize up the rear panel of AL-Dimmer-3 HP with the proper stength, as the following
figures.
3. Use the screw driver to move the 2 way dip-switch to on or off for output current option.
4. After the current was selected, to reassemble the rear panel.
2 way dip-switch
2 = on
1 = on
Output current = 700mA
2 = off
1 = off
Output current = 350mA
ON
OFF 1 2
Reassembly
Special Note!
Selects the output current of 350mA to drive 3W LED, the luminance brightness will be not enough .
Selects the output current of 700mA to drive 1W LED, the LED will be damaged.