Acclaim Lighting AL Dimmer 3 HP - Manual (Page 4)

In the mode, flip the dip-switch 10 to "ON" and the dip-switch 11
to the "OFF" position, Flip the dip-switch 1~3 to set the Fade,
dip-switch 4~6 to set the Speed and dip-switch 7~9 to set the
Pattern. Please refer to the following table for the details.
Fade Speed Pattern
1 2 3 4 5 6 7 8 9 10
ON
OFF
1 =
0=
11 12
Fadtime
(SW1~3)
Speed
(SW4~6)
Pattern
(SW7~9)
000
100
010
110
001
101
011
111
128s
64s
32s
16s
8s
4s
2s
1s
1
2
3
4
5
6
7
DipSwitch
Setting
0
14%
28%
43%
57%
71%
86%
100% Auto(Program 1~7
running in a cycle )
4.Auto Mode-Master Mode
5.IR Control (with LED Remote Operation)
4.2.Operation Instructions
4.2.1 Before operation, make sure the batteries(3V, CR2025) have been installed properly.
4.2.2 Operation Instructions
There are 8 dedicated color brightness keys(marked Red, Green, Blue, Cyan, White, Magenta, Yellow, Amber).
The "AUTO" and the "UNIT SETTING" keys, as well as Raise&Lower keys(marked for "raise" and for "lower")
are on the remote unit.
The detailed function will be illustrated in the next table.
5.1.Connecting an external connected IR EYE sensor to the AL-Dimmer-3 HP
5.1.1 Before connecting, please isolate the main power.
5.1.2 Plug the external connected IR EYE sensor into the external IR connector correctly.
5.1.3 Thus, turn the main power on.
Note:
1).Once you've confirmed all work modes and relative parameters, you can remove the external connected IR EYE
sensor.
2).NEVER remove the external connected IR sensor when powering on for preventing from the damage.
The AL-Dimmer-3 HP is available in being controlled by external connected IR EYE sensor. The IR EYE sensor
should be connected properly before operation.
IR EYE Sensor LED remote controller
-4-
In online operation, only one master AL-DIMMER-3 HP is allowed in a link. The master controls the slave
AL-DIMMER-3 HP and maximum 32pcs can be controlled.
Note: