Accusys ExaSAN SW08-Q4 - Manual (Page 14)

2. Software Installation and Configuration
Now that we have connected all hardware components and turned on the power, follow the steps in this section to
set up ExaSAN and Sanit.
2.1 ExaSAN Setup & RAID GuardX RAID Configuration
(Please refer to the A12S2-PS RAID User Manual)
2.1.1 Switch GUI Setup
The ExaSAN switch has a browser-based built-in GUI (Graphical User Interface) for administration and
configuration tasks.
2.1.2 Launch the Switch GUI
You may use either the FireFox or Safari browser to access
the switch GUI. We recommend that you use FireFox.
1. Launch the browser of your choice
2. Make sure that our private Ethernet network is
connected
3. Go to IP address 192.168.0.1
4. The GUI’s home page displays
5. Log in with default user name “admin” and password
“0000”
User Guide
P12