Activeforever Eye-Vac EVPro Electric Dust Pan - Manual (Page 7)

CLEANING THE MICRO EXHAUST FILTER HOLDER
1. The Micro Exhaust Filter Holder slides up and out of its housing on the side of the unit.
2. Gently pull the Filter out of the Filter Holder. (See Figure 4.)
3. Tap Filter gently against trash container to free and eliminate excess dirt and debris. (See Figure 5.)
4. To clean the Filter, wash in mild soap and water; rinse and dry thoroughly before using the unit.
5. If a new Filter is needed, replace with standard HEPA HF4 filter cartridges. Make sure that it fits snugly in
the Filter Holder. Replacement Filters are available through the Consumer Service Department.
6. Slide the Holder back into the unit with the Filter facing outwards.
IMPORTANT! NEVER OPERATE EYE-VAC PROFESSIONAL WITHOUT THE MICRO EXHAUST
FILTER AND FILTER HOLDER PROPERLY IN PLACE.
CLEANING THE COLLECTION BIN
The Collection Bin should be washed periodically.
1. Wash the Bin in warm water using a mild soap. Avoid harsh or abrasive cleaners or sponges. Rinse
thoroughly. TO AVOID DAMAGE, DO NOT PLACE COLLECTION BIN IN THE DISHWASHER.
2. Let it air dry. Make sure the Collection Bin is completely dry before putting it back into the EYE-VAC
PROFESSIONAL.
3. Insert the assembled Collection Bin following the instructions outlined in the USER MAINTENANCE
INSTRUCTIONS on page 4.
IMPORTANT NOTES
Other than cleaning the Dirt Filter and replacing the Micro Exhaust Filter Holder, as described in this
Owner’s Manual, this Automatic Vacuuming Dust Bin is not user serviceable. There are no user serviceable parts
inside the unit. Servicing by our Authorized Service Center is required to avoid damage to internal components.
STORAGE
1. Unplug unit and clean Collection Bin and all Filters before storing.
2. Store EYE-VAC PROFESSIONAL indoors, in a clean, dry place.
3. Never store EYE-VAC PROFESSIONAL while it is still plugged in. Never wrap cord tightly around the
appliance, use the Cord Storage area on the back of the EYE-VAC PROFESSIONAL unit. Do not put any
stress on the cord where it enters the unit, as it could cause the cord to wear and break.
WARNING!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT USE OUTDOORS OR ON
WET SURFACES.