Activeforever Krown Dual Alarm Clock with Alerting System - Manual (Page 11)

- 11 -
Mode selector:
You can choose shaker or sound and combine it with light when the alarm is triggered.
Choose shaker and light for a silent alarm. It will wake just you, and not the other. You
may turn on all three sound, light and shaker for a certainly wake up.
Reading lamp or night light:
Built-in night light or reading lamp (if table lamp is installed) will be turned On/Off
from the light switch.
Using LED indicators
Mode LEDs:
The corresponding LED will be illuminated for set up mode.
Active mode LEDs:
Under the clock display, there are four active mode LEDs.
Battery: Illuminates when the battery is installed and AC power fails. It indicates that the
clock is working with the battery source.
Sensor: Turns on when it receive of signal from an Alarm Monitor transmitter.
SCT: The SCT LED will turn on when SCT mode is selected. Alarm 1 and alarm 2 will
be de-activated.
Alarm: Turns on when the alarm clock is triggered.
Battery:
KA1000 will operate on one 8.4VDC rechargeable battery during a power outage. Do
not use a regular battery. Power is provided for the sound and the shaker only. The clock
display is blank but the time is still maintained. Consult your local solid waste collection
or disposal organization for recycling or proper disposal of batteries.
The door knock transmitter, and other transmitters, each operates on one CR2032 (in-
cluded). It is normally last for 1 year. Watch the red LED illuminate when the door knock
button is pressed, if it is dim or off, replace the battery.
ALARM SCT SENSOR BATTERY