Activeforever Krown Dual Alarm Clock with Alerting System - Manual (Page 8)

- 8 -
INSTALLATION
A. Dual Alarm Clock KA1000:
The best location to set the alarm clock KA1000 is next by the table lamp and close by
the telephone outlet in your bedroom. It also can be used in your living room or kitchen
where a lamp is available and be seen at many angles. Many KA1000 can be installed
at different locations as your desired. The Doorknock/Doorbell, the Telephone Ringer,
and the Baby Room Call transmitter are preprogrammed and when each triggers, the
alarm displays very clear the transmitter name as: ”door”, “PH”, or “Baby”. No more
confusion. No more mistaken. Follow these steps to install the alarm clock.
1. Remove the battery cover and install a 9V DC back up battery, then replace the
battery cover. (Fig 1.2 )
2. Set the alarm clock next to a table lamp. Turn the table lamp on before plugging
into the clock power cord. (Fig 2.3)
3. Plug the bed shaker to the unit and put it under the pillow. (Fig 2.2)
4. Connect the telephone module cord into the unit and plug the other end to tel
phone outlet. (Fig 2.1)
5. Plug the power cord to electrical outlet. (Fig 2.4)
B. Door Knock:
Hook the door knock on top of the door (Fig 3). Turn the door knock transmitter on.
Knock on the other side of the door to make sure it functioning properly.
C. Doorbell:
Clip the doorbell next by the doorknob is facing out. Press the button to test. (Fig 4.1
& 4.2)
Telephone Jack KA1000
Alarm Clock
Bed Shaker
Electrical
Outlet
lamp
Turn the table
lamp on before
plugging into the
clock cord.
9V battery
FIG. 4.2 FIG. 4.1 FIG. 3
FIG. 5.1
FIG. 1.1
FIG. 1.2
FIG. 2.1
FIG. 2.2
FIG. 2.3
FIG. 2.4