Activeforever AZ-1 Portable Automobile Hand Controls User Manual
Page 5
5
Operator type and usage
The AZ-1 is only produced for disabled drivers with strong hand function and good upper
mobility. And the AZ-1 is for portable use. It is not recommended to use the AZ-1 for daily
use while operating your everyday vehicle.
Installation Instructions
When installing the AZ-1 portable hand control take great care.
1. First verify that the vehicle you are driving has the following:
a. Automatic Transmission
b. Power brakes
c. Hand operated emergency brake
d. Adequate space for operator to use portable AZ-1 hand controls. Some
drivers are overweight and vehicles have small driver compartments. It is
essential that adequate space is required for a comfortable amount of hand
use while operating the AZ-1 portable hand control system. If adequate
space is not available DO NOT OPERATE THE VEHICLE with the AZ-1
portable hand controls.
2. First verify that the pedals are sufficient size to mount the clamps for the brake and
accelerator. If the pedals are not large enough to mount the portable hand controls
securely DO NOT OPERATE THE VEHICLE with the AZ-1 portable hand controls.
Brake pedal must have a design that allows safe mounting of the AZ-1.
3. You should be able to slide the brake mount over the pedal in a vertical placement.
Then tighten finger screws evenly and verify that the clamps are secure. Be sure
that the AZ-1 portable hand control system doesn’t interfere with anything that
would compromise safety. If the AZ-1 cannot be adjusted to the proper length
contact the company where you purchased and return for replacement
immediately.