Activeforever AZ-1 Portable Automobile Hand Controls User Manual
Page 7
7
6. Now you must adjust the length of the accelerator tube. By unfastening the snap
pin you can slide the accelerator tube to the safe length. The accelerator should by
approx. 2” higher then the brake handle for depression with your thumb. After
locating the length reinstall the quick release snap pin. Be sure that the pin is
latched safely. Test by pulling to verify that the snap pin is attached correctly. If for
any reason that snap pin is not securely fastened DO NOT OPERATE THE
VEHICLE with the AZ-1 portable hand controls. Test the accelerator with the
vehicle in park before driving. If the AZ-1 cannot be adjusted to the proper length
contact the company where you purchased and return for replacement
immediately.
Removing Instructions
To remove the AZ-1 portable hand controls loosen (do not remove) the finger screws to slide
the clamps over the pedals. If storing in a bag for travel it is not recommended to
disassemble the AZ-1 portable hand control. To collapse for storage remove pins and slide
the tubes to the smallest design.
Operation
Braking
• When operating the vehicle the AZ-1 portable hand controls will enable the
driver to press the power brake and accelerator with a single left hand only.