Activeforever Quasar MD Plus Advanced Light Therapy Device - Manual (Page 24)

24
Treatment Instructions for the Quasar SP
Assembly
To assemble the Quasar SP, remove it from the carrying case, plug the power
module into the power cord and simply plug the it into a 120 volt AC outlet.
Operation
Through its economy of design and technological innovation, the Quasar SP
brings professional level power and results in a portable, hand held,
photorejuvenation device.
It has three modes of operation: Continuous Wave (CW, non pulsed), Low Pulse
Frequency, and High Pulse Frequency.
When you push in the red button located at the back of the hand piece once an
indicator light located on top of the hand piece will shine green indicating the CW
mode of operation. In this mode, a tone will sound every four minutes to let you
know to move to the next area.
Push in the red button again and the indicator light will shine orange indicating
Low Frequency mode. A tone will sound every two minutes to let you know to
move to the next area.
4. A red button at back of unit is used to sequence through Modes of operation
on the Quantum Quasar.
True
False
Push in the red button again and the indicator light will shine red indicating High
Frequency mode. A buzzer will sound every two minutes to let you know to
move to the next area.
Push in the button again and the indicator light will be off.
The unit is in the off mode.
Indicator Light Modes
Green Light = CW (continuous wave), 4 minute buzzer
Orange Light = Low Frequency, 2 minute buzzer
Red Light = High Frequency, 2 minute buzzer
No Light = Off
www.ActiveForever.com