Activeforever Quasar MD Plus Advanced Light Therapy Device User Manual
Page 27
27
the wand head up to keep the skin from bunching up in front of the wand. You
may tighten the skin with your other hand if you prefer.
6. Next, move clockwise to section B. Slowly move the wand over that area for
two minutes.
7. Moving in a clockwise direction, treat section C, then section D, section E, and
last, section F.
8. Now push the button on the back of the hand piece until the indicator light
shines red.
9. Treat all six areas (A-F) for two minutes each on the high frequency mode just
as you did on low frequency mode.
10. Turn the unit off by pushing the red button at the back of the wand head until
indicator light does not shine. Grasp Concentrating Cone and slide over glass
retaining cap. Turn the unit on by pushing the red button until indicator light
shines green and use the concentrating cone to treat difficult areas such as nose,
nasal labia folds, around and between the eyes, and any other areas that the
client wants extra attention on. Treat all these areas in a period of four minutes.
13. The Quasar’s concentrating cone is used to treat difficult areas such as the
nose and around the eyes.
True
False
11. Push the red button on the back of the wand until indicator light is not shining.
You are now finished with the treatment. Total treatment should take twenty-
eight minutes.
12. Clean the equipment by wiping the wand, goggles, and concentrating cone
with alcohol. Remove the concentrating cone. (NOTE: When cleaning glass
retaining cap and glass lens, lightly tighten the lens cap and glass back onto the
wand tight enough so that the glass does not move around. Do NOT Over
Tighten. In order to produce the maximum power from the light emitting diodes
(LED), the glass must touch them. Damage may occur to the LEDs or circuit
board if the glass lens and retaining cap are over tightened.)
11. You use pliers to retighten lens retaining ring after cleaning glass.
True
False
11. Unplug the power supply from the outlet and replace all of the equipment in
carrying case.