Activeforever Quasar MD Plus Advanced Light Therapy Device User Manual
Page 26
26
1. Divide the face into 6 sections as shown in the picture below.
9. In all facial treatment instructions we divide the face into 6 areas.
True
False
2. First, split the face into left and right halves and then into three horizontal
areas. Areas C &D extend under the chin and under the jaw line. Areas B & E
extend to the base of the ears.
3. Ask the client if they have any areas that they want to concentrate on. When
you start using the concentrating cone, this will be an important point. (See
Instruction 10)
8. You ask the client if there are any areas they would want you to concentrate
on before the treatment.
True
False
4. Plug the wall mounted power supply into a 120 volt AC outlet. Push the red
button at the back of the wand head twice. The machine should now be
energized and the indicator light should be shining orange. This is low frequency
mode.
5. Starting at section A, move the wand very slowly (about an inch every 8
seconds) over that area for two minutes. A soft tone will sound, signaling you to
move to the next area. The wand head should contact the skin. It is not
necessary to push down on the wand. The weight of the wand is pressure
enough. If the client has extremely loose skin, slightly incline the leading edge of