Actron CP9180 OBD II AutoScanner Plus - Manual (Page 70)

Vehicle Diagnostics
4 – 24 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4 4
From the OBD II Function List:
1. Select O2 Monitor Test.
•Use
UP or DOWN arrow
key until O2 Monitor Test is
highlighted.
•Press
ENTER.
2. Select O2 Sensor.
•Use
UP or DOWN arrow
key until desired O2 Sensor is
highlighted.
•Press
ENTER.
✓
The O2 sensors located upstream (before catalyst) may perform
differently than ones located downstream (after catalyst).
✓
Test IDs are shown for unknown O2 sensor tests.
3. View Results of Selection.
•Use
UP or DOWN arrow
key.
OBD II Function List
=====================

View Fre eze Data
Drive Cycle Monitor
O2 Monitor Test
Diag Monitor Test
On-Board Systems
Record Data
Vehicle Information
Select O2 Sensor
=====================
O2 Bank1 Sensor1
O2 Bank1 Sensor2
O2 Bank2 Sensor1
O2 Bank2 Sensor2
O2 Bank1 Sensor1
=====================
RICH-LN
MAX:
MEAS:
MIN:
MOD:
-----(V)
0.555(V)
-----(V)
$10
thresh