System initialization – Acura 2011 RL Navigation User Manual

Page 121

Advertising
background image

120 Navigation System

System Initialization

GPS Initialization

Depending on the length of time the

battery was disconnected, your system

may require GPS initialization. If it

does, the following screen appears:

If this procedure is not necessary, the

system proceeds directly to the

Disclaimer screen (see page 17).

During initialization, the system

searches for all available GPS satellites

and obtains their orbital information.

During this procedure, the vehicle

should be out in the open with a clear

view of the sky.

If the navigation system finds the

satellites properly, this box clears and

the

Disclaimer screen is shown. If

within 10 minutes the system fails to

locate a sufficient number of satellites to

locate your position, the following

screen appears:

If the system is still unable to acquire a

signal, follow the instructions on the

screen, or contact your local dealer for

assistance.

NOTE:

The average acquiring time is less than

10 minutes, but it can take as long as 45

minutes.

Map Matching

This part of the initialization matches

the GPS coordinates found above with a

road on the

map screen. To perform this

part of the procedure, ensure that the

navigation system is displaying a map,

and drive the vehicle on a mapped road

(a road shown on the

map screen). Do

not enter a destination at this time.

When the name of the current road you

are driving on appears at the bottom of

the screen, the entire procedure is

complete. Your system is now ready to

use.

The navigation system lost power and is acquiring its
location from the GPS satellites. This usually takes
less than 10 minutes.
* Start the engine.
* Park the vehicle in an open area away from trees,
power lines, and tall buildings.
* Remove loose articles, cell phones, or electrical
accessories located near the GPS antenna.
* If this screen is displayed repeatedly when starting
the vehicle, see your dealer.

Something is interfering with the system’s ability to
acquire its location. Check the following:
* The vehicle must be in an open area with a clear
view of the sky.
* Remove sources of GPS interference like metallic
window tint above antenna, or electrical items
near antenna (see owner's manual for details).
* Check GPS antenna cable connection.
* Restart the engine and repeat the GPS acquire
procedure. If the problem persists, see your dealer.

Advertising
This manual is related to the following products: