Acura 2011 RL Navigation - Manual (Page 22)

Navigation System 21
Getting Started
Map Screen Description
Zoom In/Out
Rotate the Interface Dial knob to
change the map scale. Zooming in
increases the detail, while zooming out
gives you a wide area view. After
changing the scale, give the system a
few moments to update the display.
Map Scrolling
To view other map areas, move the
Interface Dial left, right, up, or down.
The map will shift in that direction. To
return the map to your current location,
press either the MAP/GUIDE,
CANCEL, or NAVI BACK button on
the steering wheel.
Displaying Current
Location
You can see the current address,
latitude, longitude, and elevation at any
time by doing one of the following:
• Use the voice control system and say
“Display current location.”
• Push in on the Interface Dial, select
Show Icon on Map, push in on the
Interface Dial again, and then move
the Interface Dial left to select the
CURRENT LOCATION.
The Current location screen will
appear on the display.
NOTE:
• Save is not available when the
keyless remotes are unlinked (guest
mode).
• The elevation will not appear when
the system is temporarily lacking
proper GPS information. The system
elevation may not agree with
elevations shown on roadside
elevation signs, and may fluctuate
plus or minus 100 feet or more.
You can save the current location in
your Address Book by doing one of the
following:
• Use the voice control system and say
“Save current position.”
• Push in on the Interface Dial. The
system will prompt you to save the
address. Select Save, and then push
in on the Interface Dial again.
Select Return to return to the previous
screen.