Acura 2012 TL Navigation - Manual (Page 51)

Entering a Destination
50 Navigation System
Show Map of Continental USA,
Canada and Mexico
With the USA , Canada/AK and
Mexico selection, the display changes
to:
The yellow box indicates the area you
will see when you click on the current
map with the
Interface Dial . The
scale will decrease each time you push
in on the
Interface Dial .
Use the Interface Dial to move the
crosshairs to the area of the country
close to your intended destination.
Then push in on the
Interface Dial .
If desired, rotate the Interface Dial
knob to change the map scale. When
you have the crosshairs on the desired
icon, polygon, or road, push in on the
Interface Dial . The address of the
location you have selected will appear
at the top of the screen.
NOTE:
Information icons are displayed at
scales from 1 mile to 1/4 mile, POI
icons are displayed at 1/8 mile or less,
and roads are displayed at 1/4 mile or
less.
If this is the desired address, push in
on the
Interface Dial again. If not,
use the Interface Dial to reposition
the crosshairs, then push in on the
Interface Dial again to display the
new address.
If you selected a single icon or road
segment, select
Set as Dest . to
calculate a route to the selected
destination. If you selected multiple icons
within the cursor radius, select an item
from the list. Then select
OK to calculate
a route to the selected destination.
By Go Home 1 or 2
Selecting Go Home 1 or 2 from the
DEST screen ( Dest. MENU 1 or 2 )
takes you to the address you have set as
“home.”
If a Go Home 1 or 2 PIN has been
set, the system prompts you to enter
your PIN.
Say or enter your PIN. The system will
then display the
Calculate route to
screen (see Driving to Your Destination
on page 52 ).
If a Go Home 1 or 2 PIN has not been
set, the system displays the Calculate
route to screen after you select Go
Home 1 or 2 (see Driving to Your
Destination on page 52 ).