Acura 2012 TL Navigation - Manual (Page 81)

Driving to Your Destination
80 Navigation System
Using Interface Dial to Change
Destination
While following a calculated route, you
can select a new destination with the
map screen and the Interface Dial .
With the map screen displayed,
use the Interface Dial to move the
cursor. It will change to crosshairs.
Use the
Interface Dial to position
the crosshairs on your desired new
destination, street, or icon, then push in
on the
Interface Dial . The Select an
item screen or a pop-up menu may be
displayed if there are multiple POIs in
the vicinity.
NOTE:
The
Select an item screen will be
displayed when the crosshairs are
positioned near multiple icons or
locations. A pop-up menu will be
displayed when the crosshairs are
positioned on a particular street.
If this is not your desired new
destination, press the
CANCEL button
or the BACK button to return to the
map screen. Reposition the crosshairs
with the Interface Dial , then push in
on the Interface Dial again to see the
new address.
When the Select an item screen is
displayed, select an item from the list,
and the
Calculate route to screen is
displayed. Then select OK and push in
on the Interface Dial .
When the pop-up menu is displayed,
select
New Dest . to set your location
as a replacement destination, or
Waypoint to set as a waypoint.
The system will return to the map
screen and recalculate the route to your
new destination or waypoint.