Alpine PXA-H800 - Manual (Page 12)

ALPINE PXA-H800_EN 68-13530Z69-A (B5)
10
-EN
Right side
terminal specifications Connect to:
Audio output jacks(RCA output) *
Outputs an audio signal
Connect to amplifier
RESET switch
The system of this unit is reset.
−
Commander connection terminal
Use when operating this unit from the RUX-C800
(sold separately).
Connect to the RUX-C800 (sold
separately).
Computer connection terminal (USB terminal)
Use when operating this unit via a computer.
Connect to a computer with the
USB cable accessory.
The location of the connection to the external amp for the audio output terminal (RCA output) varies, as specified below, depending on the
connected speaker system.
Speaker System CH-1(L) CH-2(R) CH-3(L) CH-4(R) CH-5(L) CH-6(R) CH-7(L) CH-8(R)
F-2way+R+SW
(4.2ch system)
Front2Way Rear Subwoofer
Front High(L) Front High(R) Front Low(L)* 1 Front Low(R)* 1 Rear(L) Rear(R) Subwoofer(L)* 2 Subwoofer(R)* 2
F-3way+SW
(2.2ch system)
Front3Way Subwoofer
Front High(L) Front High(R) Front Mid(L)* 1 Front Mid(R)* 1 Front Low(L) Front Low(R) Subwoofer(L)* 2 Subwoofer(R)* 2
F-3way+R
(4.0ch system)
Front3Way Rear
Front High(L) Front High(R) Front Mid(L)* 1 Front Mid(R)* 1 Front Low(L) Front Low(R) Rear(L) Rear(R)
F-2way+R+C+SW
(5.1ch system)
Front2Way Rear Centre Subwoofer
Front High(L) Front High(R) Front Low(L)* 1 Front Low(R)* 1 Rear(L) Rear(R) Centre Subwoofer
For details on how to set the speaker system, refer to “Setting the Speaker System (Output System Select)” in the Owner’s Manual – PC guide, or
“Setting the Speaker System (System Select)” in the Owner’s Manual – Commander guide.
* 1 An OFF setting is not available.
* 2 If connecting 2 subwoofers, the subwoofer output can be set to stereo or monaural output. If connecting a subwoofer, set the subwoofer output
(Subwoofer 2) to “OFF.” For details, refer to “Setting the Speaker System (Output System Select)” in the Owner’s Manual – PC guide, or
“Setting the Speaker System (System Select)” in the Owner’s Manual – Commander guide.
e
*
•
Sp
e