Alpine PXA-H800 - Manual (Page 6)

ALPINE PXA-H800_EN 68-13530Z69-A (B5)
4
-EN
Mou
C800
Prepa
1
Ch
A Com
C Brac
E Self-
(M4
Instal
Set
Check
it is no
Do no
an air
1
Us
or
C
e
•
5
Tightly install the bracket E at the designated paper
template position with the 4 self-tapping screws (M4 ×
14 mm) H.
Mount the brackets
symmetrically along
the paper template.
Self-tapping screw
(M4 × 14 mm) (×4)
Bracket (×4) Paper template
6
Remove the paper template.
7
Place the Base unit on the bracket E and install the
device tightly with the 4 screws (M3 x 6 mm) G.
Base Unit
Screw (M3 × 6 mm)
Mounting the Microphone.
When measuring ImprintEQ or AutoTCR before implementing
RoadEQ automated measurement, the installation position is different.
Before installing the microphone, make sure to refer to “Automatic
Measurement Function” in the Owner’s Manual – PC or Commander
guide.
For safe use, make sure of the following:
location is stable and firm.
driver’s view and operations are not obstructed.
Mount the road noise measurement microphone on the sun
visor, dashboard or roof interior.
Installation on the sun visor is the most common installation
position to measure road noise while driving.
Do not install the unit or wiring in a location that interferes
with driving or an air bag.
Microphone
Cable clamp
(Sold separately)
The mounting clip can be removed from the microphone base,
as in the illustration below. If you mount the microphone using
the base without the clip, use the supplied adhesive tape as
needed.
Microphone base
Clip
Adhesive tape
•
•
•
•
•
•