Binatone BS-8045 - Manual (Page 6)

6
OPERATION
Weighing
1. Place the scale on a flat solid horizontal sur-
face. Do not put the scale on carpets or other
soft coatings, since this will affect the accuracy of
measurements.
2. To switch on the scale, stand up onto the platform (1), evenly
distribute the weight, and stand still. Keep waiting for several
seconds, until the appliance counts the result, which will first
blinks three times on the display (2) to fix up then.
3. When measurements are over, get off from the platform (1).
The scale will automatically switches off in 8 seconds.
Note 1 : if the weight measured exceeds the permissible load
(150 kg), the display (2) will show «Err» indicating
that the permissible load has been exceeded.
Note 2 : if the scale display (2) will show «Lo», this means
that the battery is exhausted and needs replacement.
Open the compartment cover (7) and carefully
remove the battery. Observing the polarity, insert a
new battery in the appliance.
Note 3 : if after the weighing, the display (2) shows «C»,
this means that an error occurred during the weighing
process. Repeat the weighing procedure again.
Note 4 : a repeated weighing result is considered to be more
accurate.
Personal data input
Functional buttons (4-5) to input height, weight, sex and other
personal data are on the platform (1).
Allowable range of parameters:
X memory: 1-12 Users,
X height: 100-250 cm,
X age:10-100 years,
X weight: 2-150 kg,
X fat content: 4.0-60.0%
X water content: 27.5%-66.0%
User’s number
1. Press On/Set button(5). By default, the following data will
appear on the display (2): sex - male, height - 165 cm, age -
25 years. At the same time, the User’s number will be blinking.
2. Use the button (4) to increase/ decrease User’s number.
Note : at each one-time pressing of the button (4), readings
will be increased/ decreased by one.