Binatone BS-8045 - Manual (Page 7)

7
ENGLISH
Sex
1. Press On/Set button (5) to confirm the User’s age and to enter
the User’s sex input mode.
2. Use the button (4) to change the User’s sex ( / ).
Height
1. Press On/Set button (5) to confirm the User’s number and to
enter the User’s height input mode.
2. Use the button (4) to increase/ decrease the User’s height
(from 100 to 250 cm).
Age
1. Press On/Set button (5) to confirm the User’s height and to
enter the User’s age input mode.
2. Use the buttons (4) to increase/ decrease the User’s age (from
10 to 100 years).
Note 1 : if you do not introduce any datum within 15
seconds, the scale will switch off automatically.
Note 2 : while entering personal parameters, at any time you
may press the bottom part of the platform (1) to
nullify the weight readings (in this case, the display
(2)
will show «0.0») to start body weighting or the
fat/water body content measuring, using the newly
introduced or updated data.
Body fat/water content measurement
1. Switch on the scale by pressing On/Set button (5). The LCD (2)
will show either initial data set by default, or the readings of the
last weighted User.
2. By pressing the up/ down buttons (4), select your User’s num-
ber with the personal data you introduced.
Note: if you press the Direct Access button (6) with your
User’s number from1 to 4, you can immediately enter
the data input mode.
3. Before weighing, press by hand the bottom part of the platform
(1). The weight reading indication on the display (2) will high-
light «0.0».
4. Now you can stand up on the platform (1) and weigh your-
self. Keep waiting for a few seconds to allow the appliance to
calculate the result.
5. Then, under the current weight reading indication, the «BF»
title and a percentage of fat content in the body will appear.
6. After that, the «BW» title and a percentage of water content
in the body will appear.
7. Then the measured recommended calorie intake and “kcal”
will be shown in the upper part of the display (2).