Garmin NavTalk GSM - Manual (Page 12)

2
Getting Started
Section 2
Back of Unit with Battery Removed
Slide to the left and then lift up tray and
insert SIM Card
Orient card with notch to the upper right
and electrical contacts facing down.
SIM Card Installation
SIM Card
Place this side face down with the notch at
the upper right side
89490
08997
90087
4568
DYNE STK
Subscriber Identity Module (SIM) Card Installation
The SIM card (supplied by your cellular service provider) is a “Smart
Card” that includes your phone number, memory for storing phone num-
bers, messages, and service information. You can use your SIM card in any
GSM phone and you will be charged for the call. The SIM card should be
kept secure. Do not bend, scratch, expose to static electricity, or water as
damage may occur. Your SIM card is secured by a Personal Identification
Number (PIN) to discourage theft or unauthorized use. Your cellular ser-
vice provider will often perform this installation for you in order to check
the phone for proper operation.
NOTE: Switch off your unit before inserting or
removing your SIM card to prevent damage to the SIM
card memory.
SIM Card Installation/Removal
1. Switch off the unit by pressing and holding the POWER key for more
than two seconds.
2. Remove the battery pack from the back of the unit.
3. Install the SIM card by sliding and lifting the tray in the back of the
unit. Insert the card with the notch directed toward the top right side
of the opening.
4. To remove, lift up the tray and carefully extract the card.
5. Replace the tray and secure it in place. The tray must be closed and
moved to the right until it clicks in place in order for the SIM card to
function.
NvTlkGSMManual copy.indd 2 12/2/2002, 8:41:46 AM