Garmin StreetPilot 2820 - Manual (Page 55)

StreetPilot 2820 Owner’s Manual 
a
PPendix
3. Slide the bottom of the StreetPilot into the mounting base
until it clicks into place.
Mounting
base
Locking lever Release tab
4. Slide the base’s locking lever to the right (locked).
5. Plug the power cable into an available 12-Volt receptacle in
your vehicle.
6. Route the cable so it does not interfere with vehicle
operation.
Using a Remote GPS Antenna
Use an optional external remote GPS antenna (such as the Garmin
GA 25) when using the unit in a vehicle with a coated windshield
or an in-screen heating system, which can block GPS signals.
Connect the antenna to the MCX connector located on the back of
the unit. To purchase, go to www.garmin.com/products/sp2820 .
Click accessories .
Changing the Fuse
The Vehicle Navigation Kit cable has a 3AG 1.0 Amp fast blow
fuse located at the tip of the 12-Volt adapter. If you need to change
the fuse, unscrew the black, round end piece and replace the fuse.
Unscrew