Garmin GPS 75 - Manual (Page 67)

C-7
Remove the E-ring from the special screw under the base using a pair
of pliers.
· Remove the lever. A spring and detent pin are contained within a
recess on this lever.
· Unscrew the special screw and remove it from the base.
· The base, lever, detent pin, detent spring, plastic spacer, and wave
washer may be set aside (these parts are not used for surface
installation).
· Loosen the coinslot screw and slide the cradle to mid position
revealing 3 countersunk holes as shown in the figure at the bottom
of page C-5.
· Mount the surface mount to the dash using appropriate screws (#8
100 o flat head screws are recommended).
To adjust the universal mount...