Appendix, Mounting on your dashboard, Resetting your c530 – Garmin StreetPilot c530 User Manual

Page 28

Advertising
background image

20

c530 Owner’s Manual

A

PPENDIX

A

PPENDIX

Mounting on Your

Dashboard

Use the enclosed mounting disk to

mount your unit to the dashboard and to

comply with certain state regulations.
Important: The permanent mounting

adhesive is extremely difficult to remove

after it is installed.
To install the mounting disk:

1. Clean and dry the dashboard where

you are placing the disk.

2. Remove the backing from the

permanent mounting adhesive on the

bottom of the disk.

3. Place the disk on the dashboard.
4. Place the suction cup mount on top

of the disk.

Flip the

lever down

(toward the

disk).

Resetting Your c530

If your unit locks up (freezes up), press

and hold the

Power

button to turn off

the unit. Then turn the unit back on. If

this does not help, reset your c530.
To reset the c530:

1. Place your thumb nail in the groove

located under the Garmin logo on the

faceplate.

2. Gently pull off the faceplate.

Reset

button

Power button

Faceplate

3. Press the

Reset

button.

4. Connect the c530 to a power source

using the power cable. The c530

should automatically turn back on

and operate normally.

NOTE: If you need to reset your unit

often, update the system software.

See

page 23

for information about

updating the software.

Disk

Suction

cup

mount

Lever

Advertising