Garmin GPS 12MAP - Manual (Page 96)

86
Route Waypoint Deleted—The waypoint being deleted was part of a
route. The deleted waypoint is removed from waypoint memory and from
the route.
RTCM Input Failed—DGPS data being received has been lost. You are
no longer receiving the beacon signal.
Searching the Sky—The GPS 12 MAP is searching the sky for almanac
data or the unit is in AutoLocate mode.
Steep Turn Ahead—(Aviation) This message appears approximately one
minute prior to a turn that requires a bank angle in excess of 25 degrees
in order to stay on course.
Stored Data Lost—All waypoints, routes, time, and almanac data have
been lost due to battery failure, or the receiver’s memory has been
cleared.
Timer Expired—The countdown timer has expired.
Track Log Already Exists—The name selected for the track log is
identical to another track log already stored in memory.
Track Memory Full—You have used all track log points in the GPS 12
MAP. (The unit holds approximately 1900 points in the active track log.)
Delete unwanted track points to make room for new entries.
Using Simulator for Faster Data Transfer—While using the PC
Software Kit or the MapSource program, simulator mode is automatically
selected to enable a higher data transfer rate.
Waypoint Memory Full—You have used all 500 waypoints in the GPS
12 MAP. Delete unwanted waypoints to make room for new entries.
Waypoint Already Exists—The name you are entering already exists in
the GPS 12 MAP’s memory.
APPENDIX D
Messages